ZXPD3000 Pipe Locating System

This device is a high performance underground metallic pipe locating system.It consists a transmitter and a receiver, can be used to do route tracing, pipe exploration and depth measurement of the underground cables and metallic pipes.It can also be used to identify target cable from a bunch of cables,locate the pipe insulation damage and part type cable fault.

FUNCTIONS

• Compass display: to display pipe position directly.
• Real-time depth measure and current measure.
• History curve display: to display the signal variation directly.
• Cable Identification: Clamp (optional) identification and sensor identification.
• Grounding fault location: Use A frame (optional) to pinpoint pipe insulation damaged points against ground.
• Digitization high accuracy sampling and processing,narrow receiving pass band to rise the anti-interference capability and suppress power interference and harmonic interference from nearby running cable and pipe.
• Multiple locating frequency: active detection and passive detection.
• Multiple signal output mode: Direct connection output, Clamp Coupling input, Radiation output.
• Big capacity Li-on batteries series,support auto power off when low battery or long time no operation
• Solid case and light weight easy to carry

SPECIFICATION:

Transmitter:

• Output: Direct Connection output, Clamp Coupling Output (optional), Radiation output.
• Output Frequency: 640Hz (complex frequency), 1280Hz (complex frequency), 10kHz, 33kHz, 83kHz.
• Output power: max. 10W, 10 levels adjustable, auto impedance matching.
• Direct connection voltage: max. 150Vpp.
• Overload and short circuit protection.
• HMI: 128X64 LCD.
• Power supply: 4 X built-in 18650 Li-on batteries, standard 7.4V, 6.8Ah.

Receiver:

• Input: Internal receiving loop, Clamp (optional), sensor (optional),fault locating A Frame (optional).
• Receiving frequency:

- Active frequency: 640Hz,1280Hz,10kHz,33kHz,83kHz

- Power frequency: 50Hz/60Hz,250Hz/300Hz

- Radiation frequency passive frequency: center frequency 10kHz, 33kHz, 83kHz

• Pipe detection mode: wide peak method,narrow peak method,valley method
• Cable identification mode: Receiving Clamp (optional) intelligent identification / sensor (optional) identification
• HMI: 320X240 LCD
• Built-in battery: 2 X 18650 Li-on batteries, standard 7.4V,3.4Ah

Other:

• Volume: transmitter 270x220x85mm,receiver 700x270x120mm
• Weight: transmitter 2.2kgs, receiver 2.2kgs
• Charger: input AC 100~240V,50/60Hz,output DC8.4V,2A
• Temperature: -10-40℃,humidity 5-90%,elevation <4500m

underground cable fault locator equipment

underground power cable fault locator

Battery Power Underground Cable Fault Distance Locator Equipment Big Capacity Images